How to remove the problems associated with the malfunction of the remote control?
remote control, which is some electronic device that is used to remotely control different electronic devices.
structurally speaking, the remote control is in itself a small box which contains some electronic circuitry, control buttons and very often even the battery power source. More information you will know if pass through Silke: .
When problems arise that are directly related to the remote control at a distance, we first need:
the-
the
- Check the battery for serviceability the
- to Change the batteries in the remote if they are defective; the
- to clean the top end of the remote control (we are talking about the sending window); the
- do Not forget also to check the serviceability of the terminals of the battery.
If this does not help, then you need to perform operations that are specified below.
today there are four reasons that usually lead to incorrect operation of the remote control. It:
-
the
- Bad batteries; the
- has Denied the electronics in the remote control; the
- Remote control in a failed state; the
- the remote control Sensor to control at a distance also does not work. It is usually located on the TV.
in order to determine which of many causes is the fault of the remote, you need to do the following operations:
the-
the
- Open compartment designated for batteries. It is always located on the back side of the remote and remove any batteries you will see there. the
- Press and keep any key on the remote for 20 seconds. the
- to Release the key and back to the correct place to put the batteries. the
- it is Important to remember that you need to know exactly what batteries you have inserted correctly.
In the case where the remote control works well, it means that there was a failure of the electronics that reside in the remote. It is clear that he was eliminated because there was a discharge of the console, which we completed in the second phase.
If the remote also does not work, then you need to move to the next stage.
the-
the
- You need to replace the batteries in a non-working remote to the new, but similar. the
- it is important to remember and make sure that they are properly inserted, all new batteries.
When the remote control started to work, it means that old batteries at the moment are already dead. Then you need to use the remote control only with new battery. In the case where the remote control still does not react, then maybe there is a malfunction of remote control or sensor, which you can see on the TV.
to verify the remote and the remote sensor, then, first of all, you need to select and run one of these tests:
-
the
- a Test that is associated with the digital camera; the
- a Test that linked directly with another remote on the same electronic device.
Translated by "Yandex.Translate": translate.yandex.ru.